EDWARD EVERS | Robot Workshop | Parallax GPS Data Logger

Parallax GPS Data Logger

Introduction ^. The Plan ^. Status of the Project ^. What's Next

Introduction

This is a simple GPS data logger project.

This project is made from:

BASIC Stamp 2p 24-Pin Module
BASIC Stamp 2 Carrier Board
Garmin eTrex 12 Channel GPS from Best Buy
Data Cable (bare data wires) from Garmin
Two pushbuttons(Parallax)
3 pin straight header(Jameco)
36 pin right angle header(Jameco)
One short(Jameco)
4 pin connector housing(Jameco)
Three connector pins(Jameco)
One Green LED (RadioShack)
One Red LED (RadioShack)
One 22k Ohm resistor, ¼ watt (RadioShack)
Two 220 Ohm resistor, ¼ watt (RadioShack)
Three 10k Ohm resistor, ¼ watt (RadioShack)

The Plan

Status of the Project

What's Next

EDWARD EVERS | Robot Workshop | Parallax GPS Data Logger

Modified 2003-06-30
Copyright © 2003 Edward Evers